С самой низкой ценой, совершенно новый, неиспользованный, неоткрытый, неповрежденный товар в оригинальной упаковке если товар поставляется в упаковке. Упаковка должна быть такой же, как упаковка этого товара в розничных магазинах, за исключением тех случаев, когда товар является изделием ручной работы или был упакован производителем в упаковку не для розничной продажи, например в коробку без маркировки или в пластиковый пакет. Raise and support vehicle, then remove righthand splash shields. Thought it was interesting to see, and maybe correct people on bolt install procedure when installing underdrive pulleys or reinstalling crank pulley. Using the special tool, remove the crankshaft pulley 6312.
The torquing procedure supplied on the install sheet from steeda has differnt information. My friend installed the pulleys and just remembered there benig a bolt with the package. If so, new balance pins must be installed on the new damper in the same position as the original damper. Remove water pump bolts, noting location of water pump bolt with thread in bolt head for installation. I even called steeda today and they would not supply me any specific procedures because of liability. I was assuming that I just needed a new water pump, but noticed the leak was farther back. After thinking about it, I remember now asking him about it and he said the very same thing.
Crankshaft Pulley Special Tool s Crankshaft Damper Remover 303-009 T58P-6316-D Crankshaft Damper Replacer 303-102 T74P-6316-B Removal Remove the drive belt. Currently we do not use targeting or targeting cookies. Install forcing screw and tip from service kit tool No. Install crankshaft damper remover tool No. If the crankshaft damper is being replaced, check if the original damper has balance pins installed. Remove lower engine front timing belt cover bolts, then cover.
The crankshaft pulley must also be installed in the original installation position. Remove oil slinger, then woodruff key from crankshaft. This is important as the damper and pulley are initially balanced as a unit. For additional information, refer to Section 303-05. The higher number 45, gives it just a little more torque and bolt stretch to keep from backing out from under torque which is the revision change.
I used rtv at the end of the threads but didnt use loctite so i was lucky i caught it in time and now im going to keep a eye on it. This item is manufacturer drop-ship and may not be available for same day shipments. If the crankshaft pulley and vibration damper have to be separated, mark the damper and pulley so they may be reassembled in the same relative position. Use thread sealant on specified bolts. Drive the blade with a hammer from the end or the side throught the panel sam.